Mask off locations that aren't obtaining any coating. eliminate masking tape before product has completely cured.
be certain your surfaces are totally cleaned and dried. Collect all the merchandise and equipment wanted to your venture.
• It can't be placed on wet substrates or substrates nevertheless made up of moisture, else it will not remedy properly and remain tacky. Max. rest humidity in substrate might be as many as 3%. When you are Uncertain about the dampness content material, have it measured before application.
Polyolefin centered waterproofing membrane with centrally embedded glass fleece and Exclusive self-adehered fleece laminated underside
• For apps the place SEMCO Liquid Membrane™ is applied on pool plaster, prolonged curing instances might come about as plaster retains more humidity which needs to breath out first.
• Application on non porous surfaces for example metallic or fiberglass : implement thin coats as this will allow to the products to heal more quickly.
supplemental coats could be necessary depending upon the porosity of your respective substrate. For larger parts Titan defend Gloss might be applied with an airless sprayer with tip sizing seventeen. modify the sprayer to the lowest possible air location and try out on a test space initially.
• perform in little sections frivolously saturating the floor and quickly again-brush or use pad applicator to eradicate puddling, take out excess and evenly distribute PreStain.
make use of a 1/two" nap roller. make it possible for any pre-dealt with regions to fully dry. implement a skinny coat (0.015 inch for each coat) of SEMCO Liquid Membrane™ with brush or roller more than substrate together with pre-treated places. Once you can wander around the surface area and not get any residue in your shoe or feet or can not leave a fingerprint effect it is ready to re-coat. implement An additional skinny coat of SEMCO Liquid Membrane™ in an alternate route about the main coat of SEMCO Liquid Membrane™.
Polyolefin TPO (PE) centered waterproofing membrane with out glass fiber reinforcement or fleece laminated underside
• It cannot be placed on moist substrates or substrates nevertheless made up of dampness, else it will not likely cure effectively and continue to be tacky. Max. relaxation humidity in substrate is usually nearly 3%. If you're Uncertain with regards to the moisture articles, have it measured before software.
• remedy occasions are exhibited in our curing chart. on the other hand if coats are already applied as well thick, the surface may experience tacky.
• A 2nd coat is usually used if preferred. utilize more info only once ground is dry sufficient to walk on with no imprints.
Waterproofing with two element procedure In buildings employing earth sheltering, a lot of humidity is usually a potential dilemma, so waterproofing is crucial.